Disclaimer: All specifications and hours are approximate and for reference only, often based on manufacturer literature. Buyer must verify all details prior to purchase. Accessories shown are included only if listed on the invoice.
| Make: | Southwestern Industries |
| Model: | TRAK DPM RX2 |
| Features: |
|---|
| ProtoTRAK RMX 3-Axis CNC Control |
| Electronic Handwheels |
| Programmable Spindle Speeds |
| Programmable Tapping |
| Two-Speed Variable-Speed Spindle Head |
| R8 Spindle Taper |
| Manual Quill with Power Feed |
| Operator and Programming Manuals |
| Table: |
|---|
| Table Size: 49.0″ × 9.0″ |
| Number of T-Slots: 3 |
| T-Slot Width: 0.63″ |
| T-Slot Spacing: 2.50″ |
| Maximum Table Load: 1,320 lbs |
| Travels: |
|---|
| X-Axis Travel: 31.0″ |
| Y-Axis Travel: 16.0″ |
| Z-Axis Travel: 23.25″ |
| Maximum Quill Travel: 5.0″ |
| Spindle: |
|---|
| Spindle Taper: R8 |
| Low-Speed Range: 40 – 600 RPM |
| High-Speed Range: 300 – 5,000 RPM |
| Spindle Motor: 3 HP |
| Quill Diameter: 3.375″ |
| Spindle Center to Column Face: 18.5″ |
| Maximum Spindle Nose to Table: 25.5″ |
| Head Swivel: ±90 Degrees |
| Quill Feed Rates: 0.0015 / 0.003 / 0.006 IPR |
| Feedrate: |
|---|
| Rapid Traverse, X & Y Axes: 400 IPM |
| Rapid Traverse, Z Axis: 250 IPM |
| Machining Capacity: |
|---|
| Maximum Drilling Capacity: 1.0″ Diameter |
| Maximum Tapping Capacity: 3/4″-10 |
| Maximum Milling Capacity: 3 Cubic Inches per Minute |
| General: |
|---|
| Electrical Requirement: 208 Volts / 27 Amps / 3-Phase / 60 Hz |
| Approximate Overall Dimensions: 103″ W × 94″ D × 99″ H |
| Approximate Net Weight: 3,300 lbs |
