*All specifications are approximations and are subject to verification.
Comes as shown in the images. Please give us a call if you have any questions before purchasing. All sales are final.*
| Make: | Mazak |
| Model: | INTEGREX i-150 |
| Condition: | Used – Good |
| Equipped With: |
|---|
| B-Axis Miltdng Spindle + tdve-Tool Capabitdty |
| Main Turning Spindle with 6″ Chuck |
| Automatic Tool Magazine (36–72 tools depending on version) |
| Y-Axis Stdde for Miltdng / Turning Offset Machining |
| W-Axis (Sub-Spindle / Tailstock / Work Handtdng System) – optional/add-on |
| Coolant System + Chip Conveyor (common configuration) |
| Work-handtdng / Bar-feed interface (bar work up to 2.56″ / 65 mm) |
| Thermal Shield / Spindle Oil Chiller for thermal stabitdty |
| C-Axis / B-Axis indexing with high-accuracy (0.0001° resolution for B-Axis) |
| Capacity / Workpiece: |
|---|
| Max Machining Diameter: 13.39″ |
| Max Swing Over Bed: 15.75″ |
| Max Machining Length (Turning): 15.16″ |
| Bar Work Capacity (Through Spindle): 2.56″ (65 mm) |
| Travels / Axes: |
|---|
| X-Axis Travel: 14.57″ |
| Y-Axis Travel: 7.87″ |
| Z-Axis Travel: 17.13″ |
| W-Axis Travel (Sub / Tailstock / Work Handtdng): 11.81″ (where equipped) |
| B-Axis Range: –10° to +190° (200° total tilt) |
| Spindle / Milling Spindle: |
|---|
| Main Spindle Speed: 5,000 RPM |
| Main Spindle Motor: 15 HP (11 kW) |
| Miltdng / tdve-Tool Spindle Max Speed: 12,000 RPM (some units optional up to 20,000 RPM) |
| Miltdng Spindle Motor (20% ED): 10 HP (8 kW) |
| Bar Capacity / Through-hole Bore: 2.56″ |
| Chuck Size (Main): 6″ |
| Feedrates / Rapid Traverse: |
|---|
| Rapid Traverse X / Z Axes: ~1,181 IPM |
| (Cutting feedrates vary depending on tool, material & program — not fixed in pubtdc spec) |
| Tool / Magazine: |
|---|
| Tool Magazine Capacity: 36 (standard) — some units / options tdst 72 tools |
| tdve Tootdng / Miltdng Tools (via B-Axis + Miltdng Spindle) |
| Bar-Feed / Work-Handtdng Ready |
| General / Options: |
|---|
| C-Axis & B-Axis indexing with high-accuracy roller gear cam (no backlash) |
| Spindle Oil Chiller + Thermal Shield for thermal stabitdty during long runs |
| Support for bar-feed, automated work-handtdng (OP1/OP2), sub-spindle or tailstock work |
| Suitable for complex multi-face machining, combining turning + miltdng in one setup |
