Disclaimer: All specifications and hours are approximate and for reference only, often based on manufacturer literature. Buyer must verify all details prior to purchase. Accessories shown are included only if listed on the invoice.
| Equipped With: |
|---|
| Siemens Sinumerik 840D CNC Control |
| 4-Axis CNC System |
| Ambrell 8310LI Easy-Heat Induction Heating System |
| Collet Chuck |
| Hydraulic Power Unit |
| Larger Through Hole and Chuck |
| Heidenhain Glass Scale Feedback System |
| AC Spindle Drive with Regenerative Braking |
| 50 HP Spindle Motor |
| Hydraulic Tailstock |
| Workpiece Capacity: |
|---|
| Maximum Part Diameter: 6.0″ |
| Maximum Part Length: 30.0″ (Dependent on Part Configuration and Tooling Design) |
| Forming System: |
|---|
| Number of Forming Rolls: 1 |
| Number of Axial Axes: 1 |
| Number of Radial Axes: 1 |
| Axial Slide Force: 12,000 lbf |
| Radial Slide Force: 12,000 lbf |
| Axial Slide Velocity: 400 IPM |
| Radial Slide Velocity: 400 IPM |
| Type of Feedback: Heidenhain Glass Scale |
| Forming Roll Diameter: 7.0″ |
| Spindle / Headstock: |
|---|
| Spindle Nose: DIN 55022 Size 11 |
| Spindle Motor: 50 HP |
| Spindle Drive Type: AC Drive with Regenerative Braking |
| Maximum Spindle Speed: 2,000 RPM |
| Tailstock: |
|---|
| Tailstock Cylinder Travel: 29.0″ Maximum |
| Headstock-to-Tailstock Clearance: 32.0″ Maximum (Between Chuck Face and Tailstock Shaft Face, Without Tooling) |
| Maximum Clamping Force: 8,000 lbf |
| Tailstock Speed: 400 IPM |
| Weld Specifications: |
|---|
| Wall Thickness Tolerance: ±0.1 mm |
| Weld Type: Plasma, Laser, or TIG |
| Weld Thickness: 100% of Parent Material ±0.1 mm |
| Weld Flatness: ±10% of Parent Material Thickness |
| Radial Misalignment: ±5% of Parent Material Thickness |
| Axial Misalignment: ±10% of Parent Material Thickness |
| Weld Quality: Free from Voids and Impurities, Continuous from End to End, No Weld Burn-Back |
| Tube Ends: Burr-Free |
| Tube Concentricity: ±0.25 mm |
| Tube Perpendicularity: ±0.12 mm (For Length Control) |
| Hydraulic System: |
|---|
| Hydraulic Motor: 30 HP |
| Hydraulic Pressure: 2,500 PSI |
| Hydraulic Flow Rate: 50 GPM |
| General: |
|---|
| Air Requirement: 60–100 PSI |
| Power Requirement: 480V / 3-Phase / 60 Hz / 200 Amps |
| Cooling Water Requirement: 10 GPM Minimum at 80°F |
| Machine Weight: 25,000 lbs |
